Science meets practice

ReCreate – Science meets Practice

In the context of resource scarcity and climate crisis the topic of reuse is often mentioned. The aim of the EU-funded research project ReCreate: Reusing precast concrete for a circular economy is to academically  investigate possibilities for the reuse of precast reinforced concrete elements and to implement them practically in 4 pilot projects in Germany, Finland, the Netherlands and Sweden.

CIRCULAR STRUCTURAL DESIGN is part of the project as a scientific consultant and leads the Working Package 5: Redesign and Reassembly.

Building with existing components differs in key aspects from the status quo of construction practice: the design process is different, new connection details that enable reuse are required and logistical challenges have to be overcome. ReCreate is addressing these issues as part of Working Package 5.

ReCreate It all depends on the connections

Prefabricated reinforced concrete structures allow for easier, non-destructive dismantling than in-situ concrete structures. Often, only discrete connection details need to be resolved in order to remove the existing components and reuse them at component level.

Deliverable D5.2 therefore describes the existing connections in the donor buildings and common prefabricated connections in existing buildings. Particular attention is paid here to how the same connection points can be reused (with minor adjustments) during reinstallation. Connections that are to be used in the construction of the pilot projects are described. New connection types were also developed in the project, which should greatly simplify reuse in the future.

Heinze Climate Festival

ReCreate Design-guideline: Bearing-based design creation

The design process based on existing components differs fundamentally from the previous standard. It can no longer be designed freely. In the ReCreate project, the necessary work steps and as-built information are tested and documented as part of the design process of the pilot projects.

The aim is to summarize the experience gained from all pilot projects in a design guideline at the end of the project. This should inspire planners for new reuse projects in the future and show a process and the individual work steps for enabling stock-based design.

ReCreate „Best Practice Guideline“ Guidelines for a BIM-aided preconstruction audit

A structural reuse of existing components is only possible if all the necessary information (geometry, material data, load history) is available and if they have been dismantled non-destructively in the required quality. Therefore, planning for dismantling, recording, and documenting all relevant information is a crucial step in the ReCreate project. Digital workflows are suitable for collecting and documenting this information in a bundled manner.

Deliverable D5.1 was therefore a „best practice guideline“ for a BIM-aided preconstruction audit. This is publicly available at: Publications – Recreate. The focus here, due to the project’s nature, is on the dismantling of precast reinforced concrete buildings. Accordingly, commonly used precast reinforced concrete components are briefly introduced, and the possibilities of obtaining information about precast reinforced concrete buildings to assess reusability are outlined. Aspects of quality assurance are also touched upon. As a result, a “best practice recommendation” is formulated. The aim here was not to provide a precise, software-specific manual but rather a general presentation of the process.